2-34
Confidential
Unusable
Device
-
An USB device that did not meet
the specifications was inserted
into the USB port.
--- 4.14.2
Remove the
Device. Turn the
power off and back
on again.
Overcurrent was caused
because a USB device that did
not meet the specifications was
inserted into the USB port.
EC00 2-86
2-sided
Disabled
Close the Back
Cover of the
Machine.
The back cover sensor detected
the open state when 2-sided
printing is started.
(before the registration of printing
in the engine)
8903 2-64
The back cover sensor detected
the open state during 2-sided
printing. (after the registration of
printing in the engine)
8904 2-64
Reload paper, then
press Start.
The registration rear sensor
detected that the length of the
paper is too long and it may hit
within the machine in 2-sided
printing.
8A02 2-65
Error Message
State
Error
Codes
Refer
to:
Upper line Middle line