Buffalo BS-GS2016 - Page 15

QoS
QoS Settings Configure QoS priority.
QoS Mapping Configure QoS mapping for each priority.
VoIP Auto Priority Configure priority for SIP, H.323, SCCP.
DiffServ
IPv4/MAC Policy Create DiffServ policies based on IPv4 or MAC addresses.
IPv6 Policy Create DiffServ policies based on IPv6 addresses.
Port Settings Configure ports to assign each DiffServ policy.
IPv4/MAC Priority
Configure priority of each DiffServ policy based on IPv4 or MAC
address.
IPv6 Priority
Configure priority of each DiffServ policy based on IPv6
address.
Status Displays DiffServ status.
Security
Auto DoS Attack
Prevention
Configure to drop specified packets.
DHCP Snooping Configure DHCP snooping.
DHCP Table
Displays the list of DHCP clients that obtain IP addresses from a
DHCP server via the switch.
Authentication
Status Displays authentication server status.
RADIUS Configure authentication (RADIUS) server.
Port Authentication Configure authentication for each port.
Port Trunking Configure port trunking.
Traffic Control Configure traffic storm control.
Mirroring Configure to monitoring traffic.
Spanning Tree
Protocol
STP Settings Configure STP/RSTP/MSTP.
Status Displays STP/RSTP/MSTP status of each port.
Ports Configure STP/RSTP/MSTP priority for each port.
IGMP
Status Displays IGMP status.
IGMP Settings Configure IGMP snooping.
IGMP Querier Configure IGMP querier.
IGMP Router Port Specify ports to connect to multicast routers.
MLD
Status Displays MLD status.
MLD Settings Configure MLD snooping.
MLD Querier Configure MLD querier.
MLD Router Port Specify ports to connect to multicast routers.
ACL
ACL Wizard Configure ACL with wizard.
MAC ACL Create MAC address-based ACL.
IPv4 ACL Create IPv4 address-based ACL.
IPv6 ACL Create IPv6 address-based ACL.
Ports Configure ports to assign each ACL group.
IPv4/MAC Priority Configure priority of each IPv4 or MAC ACL group.
IPv6 Priority Configure priority of each IPv6 ACL group.
Status Displays ACL status.
Loop Prevention Configure loop prevention settings.
DHCP Relay
(L3 mode only)
Configure DHCP relay settings.
Management
Update Firmware Update firmware from a local file.
14
Chapter 2 Settings