LLDP-MED Port
Configure LLDP-MED for each port.
Status
If enabled, LLDP-MED will be transmitted.
Note: To use this functionality, configure the status to [Tx Only] or [Tx and Rx] on
the [LLDP Port] page.
Notification
If enabled, the SNMP trap will be sent to the SNMP server when the LLDP-MED
information in the neighbor table is updated.
Note: To use notification, configure SNMP manager and SNMP trap settings.
Capabilities TLV If enabled, the capabilities will be included in LLDP packets.
Network Policy TLV If enabled, the network policy will be included in LLDP packets.
Extend Power TLV
If enabled, the extend power will be included in LLDP packets.
Note: This functionality is compatible with PoE switches only.
Software Revision TLV If enabled, the firmware version will be included in LLDP packets.
28
To Next Page
Loading...
