Dynamic MAC Filtering
Configure the dynamic MAC filtering that enables you to set the number of MAC address learn limits for each port.
Dynamic MAC Filtering Check “Enable” to enable dynamic MAC filtering.
Number Enter the number of MAC address learning limits of each port. (1-16384)
Notes:
• If the port’s “Number” field is left blank, all MAC addresses can pass through that port.
• The number of MAC address learn limits can be set between 1-16384 for each port. However, the switch can learn
16384 MAC addresses in total. If the number of MAC address is over 16384, MAC addresses will never be learned
and will be dropped.
• When both static and dynamic MAC filtering are enabled, MAC addresses in the static MAC address table are not
counted towards the number of dynamic MAC address.
30
To Next Page
Loading...
