Buffalo BS-GS2016 - Backing Up and Restoring Settings; Technical Support

Syslog Settings
Transfer Logs Disabled
IP Address 0.0.0.0
Attach Header MAC Address and System Name
Configuration Notice + Detail
Authentication Notice + Detail
Device Notice + Detail
System Notice + Detail
Restrictions
Updating Firmware
(1) If changing the firmware to version 1.0.3.32 or earlier when the current firmware version is version 1.0.3.36 or
later and the current Settings password is longer than 8 characters, the Settings username and password will
revert to the default (the username will be “admin”, and the password will be “password”).
(2) If you do not save any changes on Settings after changing the firmware version to an earlier one, the username
and password will revert to the original if you upgrade the firmware to version 1.0.3.36 or later.
Ver.1.0.3.36 or later
Example:
Username: buffalo
Password: 123456789
Ver.1.0.3.32 or earlier
Username: admin
Password: password
(2) Change the firmware to
a newer version without
saving any changes on
Settings.*
(1) Change the firmware to
an older version.
* If you click [Apply] on any Settings page after (1), the usename and the password that had been set while
running firmware version 1.0.3.32 or earlier will remain the same after upgrading the firmware to version 1.0.3.36
or later.
87
Appendix A Specifications