SNMPv3 User
Configure information of users who are authenticated with SNMPv3. SNMPv3 will authenticate users using
username and the authentication can be encrypted. This switch is compatible with the following authentication and
encryption method.
Authentication method: HMAC-MD5-96/HMAC-SHA-96
Encryption method: CBC-DES/CFB-AES-128
Engine ID
This is the switch’s unique ID to identify SNMP engine. This ID will be notified to
other side when SNMPv3 communication is done.
Username
Enter the username to authenticate. The username should be up to 32
alphanumeric characters, hyphens (-), and underscores (_).
Access Control
Limit the access depending on the user.
Read Only
Prohibit writing.
Read/Write
Permit any access.
Authentication Method Configure the authentication method.
Authentication Key Enter the key phrase compatible with the authentication method.
Encryption Configure the encryption method.
Encryption Key Enter the key phrase compatible with the encryption method.
25
To Next Page
Loading...
