Section 9. Automating Tasks with Task Master
Pending Actions – Species the number of actions that are currently pending
for this task. This value will be zero if there are no actions currently pending.
An increasing number may indicate that you are attempting to run the task
faster than is possible.
Last File Run Started – The last time the attempt to execute the file was
started.
Last File Run Finished – The last time the attempt to execute the file was
finished.
Last File Run Outcome – The outcome of the last attempt to execute the file.
This can have one of the following values:
• Failed
• Started
• Does Not Exist
• Timed Out
Last File Run Exit Code – Windows system exit code of the last attempt to
execute the file.
Last Poll Started – The last time that polling of the specified station was
started.
Last Poll Finished – The last time that polling of the specified station was
finished.
Last Poll Outcome – The outcome of the last poll. This can have one of the
following values:
• Not Polled
• Success
• Security Failure
• Communication Failure
• Communications Disabled
• Bad Table Definitions
• Task Disabled
• Datalogger is Locked
• File Write Failure
• Datalogger is not Valid
Last FTP Started – The last time the attempt to FTP a file was started.
Last FTP Finished – The last time the attempt to FTP a file was finished.
Last FTP Outcome – Outcome of the Last FTP attempt. This will have a
value defined under Exit Codes here: http://curl.haxx.se/docs/manpage.html
In the example above, Task_1 will be run after any scheduled call with the
CR1000 station. Task_2 is a scheduled task, run on a 1 hour interval. The next
time the task will run is 05:00 p.m. on April 5, 2013. Task_3 is a calendar task.
The next time the task will run is 05:00 p.m. on April 5, 2013. Task_4 will be
run after a file is retrieved from the CR3000 station.
9-14
To Next Page
Loading...