148
In this mode, you set both the shutter speed and aperture as desired. To determine
the exposure, refer to the exposure level indicator in the viewfinder or use a
commercially-available exposure meter. This method is called manual exposure.
* <a> stands for Manual.
1
Set the Mode Dial to <a>.
2
Set the ISO speed
(p.106)
.
3
Set the shutter speed and aperture.
To set the shutter speed, turn the
<6> dial.
To set the aperture, turn the <
5
> dial.
If it cannot be set, set the <R>
switch to the left, then turn the <6>
or <5> dial.
4
Focus the subject.
Press the shutter button halfway.
X
The exposure setting will be displayed
in the viewfinder and on the LCD panel.
The exposure level mark <
h
> indicates
how far the current exposure level is
from the standard exposure level.
5
Set the exposure and take the picture.
Check the exposure level indicator
and set the desired shutter speed and
aperture.
If the exposure leve
l exceeds ±3
stops, the end of the exposure
level
indicator will display <I> or <J>.
a: Manual Exposure
Exposure level mark
Standard exposure index
If ISO Auto is set, the ISO speed setting will change to suit the shutter speed
and aperture to obtain a standard exposure. Therefore, you may not obtain
the desired exposure effect.
To Next Page
