167
You can connect the Remote Switch RS-80N3, Timer Remote
Controller TC-80N3 (both sold separately), or any EOS accessory
equipped with an N3-type terminal to the camera for shooting (p.354).
To operate the accessory, refer to its instruction manual.
1
Open the terminal cover.
2
Connect the plug to the remote
control terminal.
Connect the plug as shown in the
illustration.
To disconnect the plug, grasp the
silver part and pull.
F Using a Remote Switch
R Remote Control Shooting
With Remote Controller RC-6 (sold separately), you
can shoot remotely up to approx. 5 meters/16.4 feet
from the camera. Y
ou can either shoot immediately or
use a 2-sec. delay.
You can also use Remote Controller RC-1 and RC-5.
1
Focus the subject.
2
Set the lens focus mode switch to
<MF>.
You can also shoot with <f>.
To Next Page
