34
If you turn on the power switch and the Date/Time/Zone setting screen
appears, see page 36 to set the Date/Time/Zone.
<1> : The camera turns on.
<2> : The camera is turned off and
does not operate. Set to this
position when not using the
camera.
Whenever you set the power switch
to <1> or <2>, sensor
cleaning will be executed
automatically. (A small sound may be
heard.) During the sensor cleaning,
the LCD monitor will display <f>.
Y
ou can still shoot during sensor
cleaning by pressing the shutter
button halfway (p.44) to stop the
sensor cleaning and t
ake a picture.
If you r
epeatedly turn the power switch <1>/<2> at a short
interval, the <f> icon may not be displayed. This is normal and
not a problem.
T
o save battery power, the camera turns off automatically after 1
minute of non-operation. To turn
on the camera again, just press the
shutter button halfway (p.44).
You can set the auto power off time with [52: Auto power off]
(p.55).
Turning on the Power
About the Automatic Self-Cleaning Sensor
3 About Auto Power Off
If you set the power switch to <2> while an image is being recorded to
the card, [Recording...] will be displayed and the power will turn off after the
card finishes recording the image.
To Next Page
Loading...
