Canon GP160DF - Page 59

COPYRIGHT © 1999 CANON INC. CANON GP160 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 2 BASIC OPERATION
2-7
Image processor PCB input / output (2/2)
Figure 2-502
*1 This function only applies to units equipped with the ADF.
*2 Is only installed if the unit is equipped with a FAX function.
Image processor PCB
J214-1
-2
J211-1
-2
J219-1
-2
+24V
Document
scanner
motor
Refer to P.3-4
M61
-3
-4
-5
-6
Refer to P. 3-3
Inverter printed
circuit board
CN1-1
-2
Scanner lamp
J207
An actual check is not possible, therefore an explan
ation of the signal name has been omitted.
STMP*
DC power supply
PCB
DC controller PCB
To the ADF relay
PCB
Refer to the ADF service manual
An actual check is not possible, therefore an
explanation of the signal name has been omitted.
An actual check is not possible, therefore
an explanation of the signal name has been omitted.
When “0” , the SL303 is ON
(the document is stamped)
Stamp
solenoid *1
Speaker
J209
J201
J205
FAX modem board *2
J202
An actual check is not possible, therefore
an explanation of the signal name has been omitted.
SL303