Canon GP405 - Disassembly;Assembly

CHAPTER 5 LASER EXPOSURE SYSTEM
5-10
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
V. DISASSEMBLY/ASSEMBLY
Be sure to observe the following when disassembling/assembling the parts:
1. The power plug must be disconnected before starting the work.
2. The steps used to disassemble the parts must be reversed when assembling them, unless
otherwise noted.
3. The screws must be identified by type (length, diameter) and location.
4. The washer used with a specific mounting screw (e.g., for grounding wire and varistor) must
not be left out to ensure electric conductivity.
5. The screws that are paint-locked in place must not be removed during disassembly work.
6. The machine must not be operated with any of its parts removed, unless otherwise required.