Canon GP405 - Exposure System

CHAPTER 14 TROUBLESHOOTING
14-10
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
B. Exposure System
1 Routing the Scanner Drive Cable
Route the cable from [1] through [9]; then, go to the next item, "Adjusting the Mirror Position."
Figure 14-209
38∼39mm
Fit the mirror
positioning tool
Loosen the set screws
to free the pulley.
Put the steel ball into the
hole in the pulley.
Wind the cable 3.5
times inwardly and
4.5 times outwardly;
then, fit the
pulley clip.
Pulley clip
Steel ball
Set
screws
[2]
[7]
[1]
[4]
[2][3]
[6]
[9]
[5]
[8]