Handling rolls
Note
• How the printer operates after the paper is fed varies depending on the setting for automatic
detection of the remaining roll paper , as well as the barcode printed on rolls.
Automatic Detection
of the Remaining
Roll Paper
Barcodes
Printer Operation After the Paper is Fed
Printed The type and amount of paper left is automatically
detected based on the barcode printed on the roll.
There is no need to specify the type and length of
the paper .
On
Not printed Y ou must specify the type and length of the paper .
A menu for selection of the paper type and length
is automatically shown on the Display Screen .
( → P .1 12)
( → P .1 13)
PrintedOf f
Not printed
Y ou must specify the type of paper .
( → P .1 12)
• If the edge of the roll is bent or soiled, cut the edge of the paper . ( → P .131 )
Removing the Roll from the Printer
Remove rolls from the printer as follows.
1. Hold down the Stop/Eject button for a second or more to rewind the roll.
Important
• When a roll has been advanced, do not pull it out by force. This will prevent the paper from being
advanced.
If you accidentally pull out the paper , hold down the Stop/Eject button to enable feeding.
Next, when removing rolls from the Roll Feed Unit , see “Removing Rolls from the Roll Feed
Unit”. (→P .120)
Handling Paper 1 19
To Next Page
Loading...
Need help?
General
Weight and Dimensions
