Borderless Printing
Borderless Printing by Resizing Originals to Match the
Paper Size (W indows)
This topic describes how to enlarge originals before borderless printing to match the paper size, based on the
following example.
If you use an A1 or A2 roll for borderless printing, insert the provided Spacer for Borderless Printing on the
Roll Holder . ( → P .139)
If you do not attach the Spacer for Borderless Printing , the Platen may be soiled from borderless printing.
• Document: Any type
• Page size: 10×12 inches (254.0×304.8 mm)
• Paper: Roll
• Paper type: Heavyweight Coated Paper
• Roll paper width: 10 inches (254.0 mm)
1. In the application, create an original that takes up the entire space of the paper size.
Note
• If you can specify the margin, as in Microsoft W ord, set the margin at 0 mm. For instructions on
specifying the margin, refer to the software documentation.
2. Choose Print in the application menu.
3. Select the printer in the dialog box, and then display the printer driver dialog box. ( → P .453)
4. Make sure the Main sheet is displayed.
5. In the A Media T ype list, select the type of paper that is loaded. In this case, click Heavyweight
Coated Paper .
6. Select the print target in the E Print T arget list.
Enhanced Printing Options 301
To Next Page
Loading...
Need help?
General
Weight and Dimensions
