2- 45
Change the height of the printhead
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Aligning the Printhead
After the printhead height has been adjusted, on the printer
operation panel adjust the print mode by selecting Auto
Head Adj., and then Standard Adj.. (“Aligning the
Printhead” (→ P. 4 - 41 )
Changing Printhead Height Again
After a print job is finished and you want to perform the next
job on a different type of media, repeat the procedure to
adjust the height of the printhead “Changing Printhead
Height” (→ P.2-43), and then reset the printhead height
adjustment lever to the optimum position for the media
type.
Further, if the printhead height was changed, readjust the
printhead using the operation panel.
“Aligning the Printhead” (→ P.4-41)
To Next Page
Loading...
Need help?
General