6- 14
îš‹ Message Is Displayed
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Other Messages
Close UpperCover / Close RightCover / Close
CRG Cover
Cause 1: The cover that is displayed is open.
Solution1 Close the cover named in display.
Reset Lever
Cause 1: The release lever is up.
Solution 1: Lower the release lever.
Check Head Hght L/M/H → L/M/H
Cause 1: The current height of the printhead (displayed
at the left end of the bottom display line) is not
the appropriate height (displayed at the right
end of the bottom display line) for printing on
the type of media loaded for the print job.
Solution 1: Confirm the height (H/M/L) named at the right
end of the bottom display line, and then do the
procedure below to adjust the height of the
printhead.
1. Press the Online button to bring the printer
online.
2. Press and hold the [] or [] button for at
least 1 second to move the carriage to the
center.
3. Open the top cover.
4. Set the printhead height adjustment lever to
the correct position for the media.
5. Close the top cover.
To Next Page
Loading...
Need help?
General