6- 22
When You Cannot Print
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Cause 5: The Media Type in the media source selection
is not selected.
Solution 1: Use the printer operation panel to select the
correct setting for the media type. (→ P.2-34)
Solution 2: If the Media Type selection is incorrect, cancel
the print job in the computer side, open the
printer driver and select the correct setting for
the “print media loaded”. (→ P.1-44, P. 2 - 4)
Cause 6: No ink.
Solution 1: When the ink tank replacement message
appears, replace the ink tank for the indicated
color. (→ P. 4 -2 )
Ink initialization operation starts unexpectedly.
Cause 1: When the printer was switched off previously,
this force cancelled a cleaning operation.
Solution 1: Wait for the ink initialization operation to finish.
Ink filling may require up to 10 minutes to
complete.
Printing Halts During Print Job
Error message is displayed.
Cause 1: An error message is displayed during printing.
Solution 1: Read the message displayed in the GARO
Status Monitor or GARO Printmonitor, and
correct the problem indicated by the error
message. (→ P. 6 -2 )
Cause 2: Roll media ran out during the print job and the
tape on the trailing edge of the media sheet is
preventing the rest of the sheet from feeding.
Solution 1: Follow the procedure for removing a media jam.
Remove the used roll and replace it with a new
one. (→ P. 6- 3 7 )
To Next Page
Loading...
Need help?
General