2- 29
Printing with Rolls Media
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Loading the Roll Media
Load the roll media into the roll holder slot using the
following procedure. If there are cut sheets or printed
sheets still on the platen, remove them first.
Important
z If printing banners or other long sizes, the paper may
reach the floor after printing and the printing surface
become dirty. Wipe the floor beforehand using a clean
cloth or paper.
z If using roll media, wear clean cloth gloves when
handling the media to protect the print surface.
Note
z The platen may be fouled with ink so clean inside the
top cover before you switch to printing on a large size.
(→ P. 4- 11 )
z For more details about media that can be loaded in the
roll holder, please refer to “Media You Can Use”.
(→ P. 2- 2)
1
Open the top cover, and lift out the ejection guide.
Important
z
Do not touch any areas other than those indicated. Your
hands could get dirty or this could damage the printer.
2 If there is any roll media still present, rotate
the top of the holder stopper towards the
back, then rewind the media onto the roll and
remove the roll holder.
3 Push the holder stopper lever (a) towards the
outside to unlock the stopper, then pull out
the holder stopper and remove the roll
media.
Important
z Store unused roll media in its original package. Store
the package in a cool, dry location that is not exposed
to direct sunlight.
a
To Next Page
Loading...
Need help?
General