6- 4
îš‹ Message Is Displayed
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Media Messages
Load Roll Media
Cause 1: The printer is waiting for you to load the roll
media.
Solution 1: Load roll media of the type and size specified to
the printer using the next step. (→ P.2-28)
1. Load roll media of the specified size and
type.
2. Select the media type.
3. Select length if the media remaining
detection feature for roll media is ON.
4. Press the OK button.
Solution 2: Press and hold the Stop/Eject button for at
least 1 second to stop printing.
Remove RollMedia
Cause 1: The printer is waiting for you to remove the
ejected roll media.
Solution 1: Perform the procedure described below to
remove the roll.
1. Open the top cover.
2. Lift the release lever, and remove the roll
media.
3. Lower the release lever.
4. Close the top cover.
To Next Page
Loading...
Need help?
General