Canon imagePROGRAF W8400 User Manual

6- 5
 Message Is Displayed
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
End of Roll
Cause 1: The roll media has run out.
Solution 1: Do the procedure below to load the same size
and type of roll media in use. (→ P.2-28)
1. Load size and type of roll in use.
2. Select the media type.
3. Select length if the media remaining
detection feature for roll media is ON.
4. Press the OK button.
RllMed.Shortage
Replace RllMed
Cause 1: Data received is to print a size longer than the
remaining roll media.
Solution 1: Load new roll media to the printer using the
following procedure. (→ P. 2- 2 8 )
1. Load a new roll media of the same size and
type of roll in use.
2. Select the media type.
3. Select length if the media remaining
detection feature for roll media is ON.
4. Press the OK button.
Solution 2: Press and hold the Stop/Eject button for at
least 1 second to stop printing.

Canon imagePROGRAF W8400 Specifications

General

Brand	Canon
Model	imagePROGRAF W8400
Category	Printer
Language	English