5- 47
îš‹ Initializing the Network Settings
トップ
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
TOP
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Initializing the Network Settings
Follow the procedure below to use the Web browser
(Remote UI) to restore all the network settings to the factory
default settings.
Note
z In addition to using the Web browser to restore the
default settings, you can also use GARO Device Setup
Utility or the printer operation panel to restore the
default network settings.
1 Start the Web Browser and enter the
following URL in the Location or Address
box, then press the Enter key.
http:// <Printer IP Address or name> /
Sample: http://XXX.XXX.XXX.XXX/
2 Select Administrator Mode and then click
the Logon button.
When Remote UI is started with the network card set to
the factory default settings, the English screen will be
displayed. Set
Language
to
Japanese
, select
Administrator Mode
, and then press the
Logon
button.
Remote UI starts.
Note
z If a password has been setup on the printer, enter the
password and then press the OK button. If a password
has not been setup, you do not need to enter a
password.
3 From the Device Manager menu on the left,
select Network.
4 Click the Reset to Default Settings button.
5 Verify the message then click the OK button.
All network information is restored to the default
settings.
Note
z When you initialize the network settings, the printer IP
address setting is changed to the factory default value
of (0.0.0.0), so the remote UI screen is not displayed
again in the browser. Set it through GARO Device
Setup Utility or printer operation panel if you set the
network settings.
To Next Page
Loading...
Need help?
General