EasyManuals Logo

Canon imagePROGRAF W8400 User Manual

Canon imagePROGRAF W8400
421 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #316 background imageLoading...
Page #316 background image
5- 20
îš‹ Macintosh Network Settings
トップ
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
TOP
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Macintosh Network Settings
This section describes how to connect to a network using
AppleTalk, IP Print, Canon IP (GARO) and Zeroconf and
provides procedures for setting up the printer for use.
Procedures Required for a Macintosh
Network
The following is a summary of the procedures required to
setup the printer for use on a Macintosh network.
The following procedures should be performed by the
network system administrator.
Note
z This section describes examples where the printer is
connected to the Ether port (built-in Ethernet) which
is standard on Macintosh computers. To connect to the
printer using wireless LAN or an expansion network
interface board, select the port name.
z If you are using Mac OS 8.6/9.x, the printer can be
used over the IP Print network. IP Print uses the TCP/
IP protocol. For IP Print (Auto), if the TCP/IP settings
have been enabled on the Macintosh computer, the
printer can be used simply by connecting it to the LAN.
To connect to the printer using IP Print, first save the
IP address of the printer using Registering IP
Address... in Chooser, and then select IP Print and
the printer name.
1 Installing the Network Interface Board
→ Quick Start
Guide
First, install the optional network interface board.
2 Connecting the LAN Cable → P. 5- 5
Connect the LAN port in the printer to the hub using a
network cable.
3 Configuring a Macintosh → P.5-21
• Check the Macintosh network settings.
4 Configuring the AppleTalk Protocol → P.5-25
To connect to the printer using AppleTalk, enable the
AppleTalk protocol on the printer. To set the printer
name and zone, or to connect to the printer using IP
print or Canon IP (GARO), set the printer IP address
using the operation panel before configuring the
protocol settings using the web browser.
5 Install the Printer Driver → P.5-31
Follow the procedure in the Quick Start Guide to
install Canon imagePROGRAF printer driver on the
Macintosh.

Table of Contents

Other manuals for Canon imagePROGRAF W8400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Canon imagePROGRAF W8400 and is the answer not in the manual?

Canon imagePROGRAF W8400 Specifications

General IconGeneral
BrandCanon
ModelimagePROGRAF W8400
CategoryPrinter
LanguageEnglish

Related product manuals