5- 24
Macintosh Network Settings
トップ
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
TOP
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
z For Mac OS X
Confirm the TCP/IP settings under Network in System
Preferences.
Important
z To connect to the printer using the Zeroconf function,
the printer and computer need to be connected to the
same network segment. It is not possible to connect to
a printer on another network via a router using
Zeroconf. For network settings, consult your network
administrator.
z If the server cannot be found when Using DHCP is
selected, then “169.254.xxx.xxx” is set as the Link
Local Address. In this case, start the DHCP server on
the network, or consult your network administrator.
1 Open Network under System Preferences.
2 Set the Show setting to Built-in Ethernet.
3 Select the TCP/IP panel and confirm that the
IP address, subnet mask, and router settings
are valid.
4 Close Network to save the settings.
This completes the TCP/IP network settings for a
Macintosh.
To Next Page
Loading...
Need help?
General