5- 28
Macintosh Network Settings
トップ
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
TOP
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
z If you change the Name, use 31 single-byte (15
double-byte) characters or less. Note that the following
single-byte characters cannot be used: @, *, :, =.
7 If a zone has been setup on the network,
enter the name of zone where the printer
belongs.
If no zones have been setup, then leave the asterisk
“*” entry (default zone) as it is.
Important
z Make sure you enter the correct zone name in single-
byte characters. If the zone name you enter is different
from the zone setting, the Macintosh computer will not
recognize the printer. For zone names, consult you
network administrator.
8 Click the OK button.
If you are using AppleTalk only, go to Step 13.
9 If you are using the Zeroconf function to
connect to the printer, click the Edit button to
the right of TCP/IP.
The Edit Apple Talk Protocol Settings page
opens.
To Next Page
Loading...
Need help?
General