6- 39
îš‹ Removing Media Jams
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
7 Grasp the center of the roll media edges and
gently pull out the roll media until it is over
the ejection guide. Next, align the right edge
of the roll media with the right of the paper
alignment line (b), and lower the release
lever.
Important
z Do not pull strongly on the roll media when you align it
with the paper alignment line. The roll media may not
feed out straight in some cases.
z If you pull too much of the roll media out, more of the
leading sheet than is needed will be cut.
8 Close the top cover.
9 If the printer is OFF, press the Power button
to turn ON the printer.
The media starts to feed, and the printer is ready to
use after feeding is finished.
Note
z If you need to correct the alignment of the leading
edge, press the Online button to display Offline, press
the [] button to feed the media, then select Force
Cutting on the MAIN MENU to cut the leading edge.
(→ P. 7- 3 )
z
If replacing the roll media and changing the paper type,
set the new paper type using the menu. (
→
P. 2- 34 )
Data
Information Power
Offline
Menu
Message
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)
To Next Page
Loading...
Need help?
General