Canon Oce BLM550+

To Next Page

To Previous Page

Adjust the NUMBER of forms setting. Increase the NUMBER of forms to

create more spine form and decrease the NUMBER of forms to create

less spine form.

Does the problem persist?

Yes No

No further action is required.

Load a Default Job. This will reset the FORM settings, including PRES‐

SURE, NUMBER and THRESHOLD (see

Reset the Booklet maker to de-

fault settings

on page 42).

Does the problem persist?

Yes No

No further action is required.

Run a standard job using paper of 80 g/m² (20 lb bond).

Does the problem persist?

Yes No

The problem is caused by the cover material or

the finish on the cover. Change the cover ma-

terial.

Re-reference the machine. Touch ADVANCED > RE-REF > RE-REF to re-

reference the machine.

Does the problem persist?

Yes No

No further action is required.

Call your service engineer.

Book Quality

Chapter 6 - Error Conditions, Problems and Solutions

Canon Oce BLM550+ - Page 67