¦
¦
V
No further action is required.
Call your service engineer.
Trimming problem - the book is not trimmed square
Open the trim stop guard and check for paper trimmings (see
Clear paper from the trim stop
on
page 129).
Is the trim stop clear of paper trimmings?
Yes No
¦
¦
¦
¦
¦
¦
V
Clear paper from the trim stop.
Does the problem persist?
Yes No
¦
¦
V
No further action is needed.
Call your service engineer.
Trimming problem - poor trim quality
The trim process uses a double-edge blade to cut thick books. This can leave a small mark in the
center of the trimmed edge. The visibility of this mark will depend on the paper quality and
characteristics.
[26] Blade witness mark in the center of the book
[27] Blade damage mark
Are there marks on the trimmed edge other than the blade witness mark?
4
Book Quality
72
Chapter 6 - Error Conditions, Problems and Solutions
To Next Page
Loading...