Change the Print Delivery Settings
Introduction
Usually the print delivery settings have been defined in the printer driver. This section describes
how to change some settings on the control panel.
Overview of the print delivery settings
Setting Description
[Output tray] Change the output location for the job. The list shows all the out-
put locations that are available for your system.
Make sure there is a match between the selected output location
and the job requirements. For example, when a job requires sta-
ples, you must select an output location that allows stapling.
[Sort] Change the sorting method of the prints. You can select sort [By
page] or [By set].
Sort by page
Sort by set
[Offset stacking]
Stack the prints with an offset.
This setting is only available when the [Offset stacking] setting of
the active [Workflow profile] is set to [As in job].
[Advanced settings] Finishing equipment often requires that the printed sheets are de-
livered in a certain order. For finishers that are integrated in your
printing system, the required settings are adapted automatically.
However, sometimes it can be necessary to change a number of
settings manually, for example when you want to finish the prints
using offline finishers. If required, you can change the [Sheet or-
der], [Sheet orientation], [Print order] and [Rotation].
Change the Print Delivery Settings
218 Chapter 8 - Carry out print jobs
Canon varioPRINT 140 series
To Next Page
Loading...
