Canon varioPRINT 140 Series - Define a New Automated Workflow

Define a new automated workflow
An automated workflow bundles a series of pre-defined job properties.
1. Open the Settings Editor and go to: [Workflow]→[Automated workflows].
Workflow tab
2. Use the [Add], [Edit] or [Copy] function.
Automated workflow menu
3. Define the settings (see Define the settings of an automated workflow on page 78).
NOTE
It is not mandatory to define all the settings. When you put a check mark in front of
a setting, that setting and its values become enabled.
4. Click [OK].
NOTE
If needed, you can delete one or more automated workflows or restore the factory defined,
default automated workflow.
You cannot delete the factory default automated workflow.
Define a new automated workflow
Chapter 5 - Prepare the print system 77
Canon varioPRINT 140 series