Canon varioPRINT 140 Series - Finishers

Finishers
This topic describes the parts of the following finishers:
• Stacker/stapler
• Folder
• Long sheet catch tray
• Bridge and finisher adapter for DFD (Document Finishing Device)
Stacker/stapler
There are two standard stacker/stapler configurations: the stacker/stapler with booklet maker
(Booklet Finisher-AC and without a booklet maker (Staple Finisher-AC. The booklet maker folds
and staples booklets. Both finisher configurations can have the optional punch unit to punch two,
three or four holes in the printed output.
The dashboard of the control panel displays the status of the staple cartridges. When the colour
of the staple icon is orange or red, the staple cartridge needs replacement.
10 9
2
7
7
6
5
1
8
4
6
5
4
3 2
1
3
Stacker/stapler with booklet maker (Booklet Finisher-AC), punch waste tray and standard stacker/stapler without
booklet maker (Staple Finisher-AC)
Description stacker / stapler
1 Tray to collect finished output
2 Tray to collect finished output
3 Staple button to manually staple the sheets in the stapling slit
4 Cover to access the area where you replace staple cartridges, clear a paper jam, clear
a staple jam, or remove punch waste
5 Media jogger to align printed output
6 Stapling slit to place sheets for manual stapling
7 Cover to access the area where you replace staple cartridges, clear a paper jam or
clear a staple jam
8 Booklet tray to collect booklets
9 Tray to collect finished output
10 Punch waste tray to collect the punch waste
Finishers
26 Chapter 2 - Explore the print system
Canon varioPRINT 140 series