46 Chapter 6 Acquiring 3D Images
Launching the X-ray
To launch the X-ray, follow these steps:
1. Leave the X-ray room and close the door. You must keep visual contact with the patient during
acquisition.
2. Launch the X-ray with the remote control. Press and hold the exposure button until the end of the
acquisition is indicated by the on-screen “Release Handswitch” message. The turns yellow
and a warning sound is heard, indicating X-ray emission. When the acquisition ends, the
Acquisition Interface disappears and the volume is set under reconstruction. During
reconstruction, release the patient and remove the hygiene barrier from the bite block.
3. Open and review the volume from you imaging software.
Important: To stop the acquisition, if there is any problem, release
the exposure button of the remote control or press the red
emergency stop button.
To Next Page
Loading...
