20060301
Example 2: To change from the Standard mode to the Decimal mode (page 2-2-6), and then
re-calculate
u
ClassPad Operation
(1) Move the cursor to the location from which you want to re-calculate.
• In this example, we will tap the end of line 2 to locate the cursor there.
(2) Tap “Standard” on the status bar to toggle it to “Decimal”.
(3) Tap
w
.
• This recalculates all of the expressions starting from the cursor position, and displays
the results using Decimal mode format.
2-3-3
Using the Calculation History
Tip
• You can also change to Decimal mode by tapping
s
on the icon panel and then tapping [Basic
Format]. Select the “Decimal Calculation” check box and then tap [Set].
• To re-calculate only a single specific line, tap
D
. Tapping
D
re-calculates the calculation
where the cursor is currently located only. It does not affect anything in calculation history that
comes before or after the line.
• To re-calculate all of the expressions in the calculation history, locate the cursor in the top line,
and then tap
w
.
Re-calculated
To Next Page
Loading...
