20060301
(3) Enter 20 and then tap [OK].
• This will run OCTA and display the results
in the program output window.
(4) To close the program output window, tap anywhere inside it and then tap the
S
button
in upper right corner.
Program output window
2-13-2
Running a Program in the Main Application
Example:
To run the program named OCTA that we created and stored under “Creating
and Saving a Program” (page 12-2-1) from the Main application, and determine
the surface area and of a regular octahedron with a side length of 20 cm
u
ClassPad Operation
(1) Perform the key operation below in the Main application work area.
0E
OCTA
9
()
(2) Tap
E
.
To Next Page
Loading...
