20060301
u
To insert new input into the middle of an existing calculation expression
Use
d
or
e
to move the cursor to the location where you want to insert new input, and
then input what you want.
Example: To change 2.36
2
to sin(2.36
2
)
(1)
c
9
c.dg
x
(2)
dddddd
(3)
T
s
Tip
• You can move the cursor without using the cursor key by tapping at the destination with the stylus.
This causes the cursor to jump to the location where you tap.
u
To replace a range of input with new input
After you drag the stylus across the range of input that you want to replace, enter the new
input.
Example: To replace the “234” of “1234567” with “0”.
(1) Input “1234567”.
c1234567
(2) Drag the stylus across “234” to select it.
(3) Input “0”.
0
Tip
• You can perform
d
and
K
key operations by pressing the corresponding keypad key or soft
key.
1-6-6
Input
To Next Page
Loading...
