OPERATION & MAINTENANCE MANUAL STE35SR
After adding fuel or oil, wipe up any spilled fuel or oil.
When carrying out grinding or welding work on the machine, move any flammable
materials to a safe place before starting.
When washing parts with oil, use a non-flammable oil. Diesel oil and gasoline may catch
fire, so do not use them.
Put greasy rags and other flammable materials into a safe container to maintain safety at
the work place.
Do not weld or use a cutting torch to cut any pipes or tubes that contain flammable
liquids.
Fire Caused by Accumulation of Flammable Material.
Remove any dry leaves, chips, pieces of paper, dust, or any other flammable materials
accumulated or affixed around the engine, exhaust manifold, muffler, or battery, or inside of the
machine.
Fire coming from electric wiring
Short circuits in the electrical system can cause fire.
Always keep electric wiring connections clean and securely tightened.
Check the wiring every day for looseness or damage. Tighten any loose connectors or
wiring clamps. Repair or replace any damaged wiring.
Fire caused by piping
Check that all hoses and pipe clamps, shields and cushions are firmly fixed in place. If
loosened, vibration and friction with other parts will occur during operation, resulting in
damage to hoses, high-pressure oil ejection, fire hazards or personal accidents.
Explosion Caused by Lighting Equipment
When checking fuel, oil, battery electrolyte, window washer fluid, or coolant, always use
lighting with anti-explosion specifications. If such lighting equipment is not used, there is
danger of explosion that may cause serious injury.
When taking the electrical power for the lighting from the machine itself, follow the
instructions in this manual.
Action in Case of Fire
If fire occurs, escape from the machine as follows.
Turn the start switch OFF to stop the engine.
Use the handrails and steps to get off the
machine.
Falling Objects, Flying Objects and Intruding
Objects Prevention
On jobsite there is a hazard that falling objects,
flying objects, or intruding objects may hit or enter
the operator's cab, consider the operating
conditions and install the necessary guards to
protect the operator.
When carrying out demolition or breaker
operation, install a front guard and use a
laminated coating sheet on the front.
When working in mines or quarries where there is
a hazard of falling rock, install FOPS (Falling
Objects Protective Structure) and a front guard,
and use a laminated coating sheet on the front
glass.
When carrying out the above operations, always
close the front window. In addition, always ensure
that standers-by are a safe distance away and
are not in hazard from falling or flying objects.
To Next Page
Loading...