Ciena 6200 - Logging into an Uncommissioned 6200 Network Element

Nodal commissioning 6-3
6200 Packet-Optical Platform Installation, Commissioning, and Testing Procedures
Release 1.1 009-6200-201 Draft Issue 1
Copyright
©
2014 Ciena
®
Corporation September 2014
Procedure 6-2
Logging into an uncommissioned 6200 network
element
Use this procedure to log into the 6200 network element through the web user
interface (WUI).
Prerequisites
• Ensure that the PC is connected to the Craft interface of the network
element through a cable with RJ-45 connectors.
• Launch the web browser.
Action
Step Action
1 Ensure that the following circuit packs are fully inserted in the 6200 chassis:
two PSU circuit packs, fan modules, one Fan+OAM or Fan+OAMV2 circuit
pack and aggregate circuit packs.
2 Ensure that the power is turned on for the power feeds connected to the two
PSU circuit packs.
3 Launch the
web browser and enter the URL.
http://192.168.1.254:20080/
4 Determine your next step.
5 At the login prompt, enter the default userid and password.
The Navigation menu of the network element is displayed.
NE information is the default page of the WUI.
CAUTION
Risk of unauthorized access
Change the initial password of the default user account on the
network element. The default user accounts and passwords
are widely known.
If Then go to
the login screen appears step 5
the network element does not
respond
step 7 on page 6-4
where is
userid ADMIN
password ADMIN