Ciena 6200 - Preventing Circuit Pack Damage, Pluggable Module and Fan Module Damage

1-16 Observing product and personnel safety guidelines
6200 Packet-Optical Platform Installation, Commissioning, and Testing Procedures
Release 1.1 009-6200-201 Draft Issue 1
Copyright
©
2014 Ciena
®
Corporation September 2014
Preventing circuit pack damage, pluggable module and fan module
damage
Note: In this section, the generic term “module” is used to refer to circuit
packs or pluggable modules as applicable.
All modules are subject to damage by rough handling or by electrostatic
discharges. Review the following sections for more information on how to
prevent damage to modules. If Ciena ships modules separately from the
network element shelf, then these circuit packs can come in shielded
containers marked with the following symbol:
Handling, installing, storing, or replacing circuit packs, pluggable
modules and fan module
When you handle, install, or replace modules, you must take the following
precautions:
• Wear an antistatic wrist-strap, a heel grounder, or another personal
grounding device before you remove a module from its package or from
the shelf.
• Follow installation and removal procedures for each module. Make sure to
understand and perform each precautionary message in these
procedures (for example, opening/closing the latches of the circuit pack
simultaneously).
• Do not touch the solder side of the module, the pin connector, or the
components.
• Inspect all pin connectors on each module for damage before use.
• Inspect each module for damage before you insert the component into the
shelf.
• Store uninstalled modules separately in a shielded box.
• Do not stack modules on or against each other.
• Do not force modules into their packaging material.
• Do not store several modules in the same container.
• Allow each module to reach room temperature before you insert the
module into the shelf.
ATTENTION
OBSERVER LES
PRÉCAUTIONS. MANIPULER
LE MATERIEL SENSIBLE A
L’ELECTROSTATIQUE EN
SUIVANT LES MESURES DE
SECURITE
ATTENTION
FOLLOW PRECAUTIONS
FOR HANDLING
ELECTROSTATIC SENSITIVE
DEVICES