Observing product and personnel safety guidelines 1-15
6200 Packet-Optical Platform Installation, Commissioning, and Testing Procedures
Release 1.1 009-6200-201 Draft Issue 1
Copyright
©
2014 Ciena
®
Corporation September 2014
product you are working on, such as the shelf ESD jack. Grounded fixtures are
accessible on most Ciena products. See the ESD ground jacks shown in
Figure 1-3.
The following guidelines provide optimal electrostatic discharge protection:
• Install bays on conductive floor coverings.
• Provide conductive shoes, antistatic wrist-straps, and heel grounders to all
personnel working on the equipment.
• Maintain local environmental conditions so that relative humidity around
equipment to be serviced is in excess of 20% (preferably higher than
40%). This lowers the threat of developing damaging electrostatic levels.
• You can implement an ESD training and control program that educates
personnel on the hazards of ESD and simple mitigation procedures that
can easily be applied.
Figure 1-3
ESD jack location on the 6200 optical equipment
To Next Page
Loading...