6-10 Nodal commissioning
6200 Packet-Optical Platform Installation, Commissioning, and Testing Procedures
Release 1.1 009-6200-201 Draft Issue 1
Copyright
©
2014 Ciena
®
Corporation September 2014
Procedure 6-5
Setting the 6200 date and time
Use this procedure to edit the network element date and time.
Prerequisites
Log into the network element WUI and display the NE information page.
Action
Step Action
Setting the date and time of a network element
1 Click System Time in the Navigation menu.
2 Click Set time link.
Set Node Time page is displayed.
3 Set date and time by selecting appropriate values from the drop down menu.
4 Click Submit.
Changes are applied and a confirmation message is displayed.
Setting the time zone of a network element
5 Click System Time in the Navigation menu.
6 Click Set time zone link.
Set Time Zone page is displayed.
7 Set the time zone by selecting appropriate value from the drop down menu.
8 Click Submit.
Changes are applied and a confirmation message is displayed.
9 In case the drop down menu does not display the desired time zone, click on
Other Time Zones.
Other time zone page is displayed.
10 Enter the name of the time zone, the Offset value, Enable Day light saving
from drop down menu and set the following Day light saving time parameters:
• DST String
• DST Start
—Month
—Week
—Day
—Hour
—Minute
To Next Page
Loading...