Ciena 6200 - Verifying Association between 6200 and Other Network Element

System testing 7-61
6200 Packet-Optical Platform Installation, Commissioning, and Testing Procedures
Release 1.1 009-6200-201 Draft Issue 1
Copyright
©
2014 Ciena
®
Corporation September 2014
Procedure 7-13
Verifying association between 6200 and other network
element
Use this procedure to verify association between the 6200 and other network
elements in the network.
Prerequisites
Log into the network element WUI and access the NE information application.
Action
Step Action
1 Click Maintenance in the Navigation menu.
2 Click Diagnostics.
3 Click DCN Monitor.
4 Determine the next step
Note: OSPF monitor and ilsls monitor options are available only if they are
enabled. For more information, refer to Local Craft Access User Guide,
009-6200-195.
OSPF monitor
5 Click OSPF Monitor.
OSPF monitor page is displayed.
Note: Only OSPF enabled network elements in the network will be shown as
neighbors.
6 Click Neighbors to view the network elements in the network.
Network elements connected to the 6200 via OSPF are displayed, along with
the IP address.
This verifies the association between 6200 and other network element in the
network.
iIsIs monitor
7 Click iIsIs monitor.
Routing information page is displayed.
If you are using Then go to
OSPF monitor step 5
iIsIs monitor step 7