DescriptionField
•
User Name and Password: Enter the user name
and password that you use to log in to your ISP
network through a PPPoE connection.
•
Service Name: If provided by your ISP, enter
the Service Name.
•
Connect on Demand: You can configure the
ATA to disconnect your Internet connection
after a specified period of inactivity (Max Idle
Time). If your Internet connection has timed
out, this feature also enables the ATA to
re-establish your connection when you attempt
to access the Internet again. If you choose this
option, also set the Max Idle Time.
•
Keep Alive: This option keeps you connected
to the Internet indefinitely, even when your
connection sits idle. If you choose this option,
also set the Redial Period, which is the interval
at which the ATA verified Internet connectivity.
The default period is 30 seconds.
If needed, you can adjust the MTU and Optional
Settings.
PPPoE Settings
The Maximum Transmission Unit (MTU) setting
specifies the largest protocol data unit (in bytes)
permitted for network transmission. Generally, a
larger MTU means greater efficiency. However, a
larger packet may cause delays for other traffic and
is more likely to become corrupted. Usually, you keep
the default setting to allow the ATA to choose the
appropriate MTU. To specify the MTU, select
Manual, and then enter the number of bytes.
MTU
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
17
Network Configuration
IPv4 Settings
To Next Page
Loading...
Need help?
General
