To Next PageTo Next Page
What does 'Unknown error occurred while configuring IDB' mean on my Cisco Switch?
This error on your Cisco Switch suggests that the MFSC could not create the internal interfaces for the CSM. Try reprogramming the MFSC or the IDPROM.
What does 'Standby is not monitoring active now' mean on my Cisco Catalyst 6500 Switch?
This problem on your Cisco Switch results from a version mismatch of the fault tolerance protocol between two versions of the CSM. The CSM does not support hitless (HA) upgrades in this situation.
General| Product Type | Switch |
|---|---|
| Switch Type | Modular |
| Switching Capacity | Up to 720 Gbps |
| Forwarding Rate | Up to 400 Mpps |
| Modular | Yes |
| Uplink Ports | Varies by module |
| QoS | Yes |
| Rack-mountable | Yes |
| Series | Catalyst 6500 |
| Power over Ethernet (PoE) | Available on some models |
| Operating System | Cisco IOS |
| Redundancy | Yes (Supervisor engine, power supply) |
| Form Factor | Chassis-based |
| Slot Count | 3, 6, 9, or 13 slots |
| Management | CLI, SNMP |
| Security Features | ACLs, 802.1X, port security |
| VLAN Support | Yes |
