Cisco MWR 2941 - Page 119

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
dot1q tunneling ethertype
101
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Examples The following example shows how to configure an Ethertype field as 0x9100:
Router(config)# interface gigabitethernet 1/0/0
Router(config-if)# dot1q tunneling ethertype 0x9100
Related Commands Command Description
encapsulation dot1q Enables 802.1Q encapsulation of traffic on a specified subinterface or range
of subinterfaces.
interface Configures an interface and enters interface configuration mode.