EasyManua.ls Logo

Cisco MWR 2941 - Revision

Cisco MWR 2941
708 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
revision
379
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
revision
To set the revision number for the Multiple Spanning Tree (802.1s) (MST) configuration, use the
revision command in MST configuration submode. To return to the default settings, use the no form of
this command.
revision version
no revision
Syntax Description
Defaults version is 0.
Command Modes MST configuration (config-mst)
Command History
Usage Guidelines Two Cisco 7600 series routers that have the same configuration but different revision numbers are
considered to be part of two different regions.
Caution Be careful when using the revision command to set the revision number of the MST configuration
because a mistake can put the switch in a different region.
Examples This example shows how to set the revision number of the MST configuration:
Router(config-mst)# revision 5
Related Commands
version Revision number for the configuration; valid values are from 0 to 65535.
Release Modification
12.2(14)SX Support for this command was introduced on the Supervisor Engine 720.
12.2(17d)SXB Support for this command on the Supervisor Engine 2 was extended to
Release 12.2(17d)SXB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
instance Maps a VLAN or a set of VLANs to an MST instance.
name (MST configuration submode) Sets the name of an MST region.
show Verifies the MST configuration.
show spanning-tree Displays information about the spanning-tree state.
spanning-tree mst configuration Enters MST-configuration submode.

Table of Contents

Related product manuals