Cisco MWR 2941 - Network-Clock-Select Hold-Timeout

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock-select hold-timeout
283
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
network-clock-select hold-timeout
The network-clock-select hold-timeout command specifies how long the router waits before
reevaluating the network clock entry. To remove a network-clock-select hold-timeout configuration,
use the no form of this command.
network-clock-select hold-timeout {timeout | infinite}
no network-clock-select hold-timeout {timeout | infinite}
Syntax Description
Defaults The default setting is network-clock-select hold-timeout infinite.
Command Modes Global configuration
Command History
Examples The following example shows how to use the network-clock-select command:
Router# config t
Router(config)# network-clock-select hold-timeout 2000
Router(config)# exit
Related Commands
timeout A value in seconds that specifies how long the router waits before
reevaluating the network clock entry. Valid values are a number from
0–86400.
infinite Specifies an infinite holdover.
Release Modification
12.4(19)MR2 This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
set network-clocks
force-reselect
Forces the router to re-select the network clock.