Cisco MWR 2941 - Show Cns Config Connections

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show cns config connections
468
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
show cns config connections
To display the status of the Cisco Networking Services (CNS) event agent connection, use the show cns
config connections command in privileged EXEC mode.
show cns config connections
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Usage Guidelines Use the show cns config connections command to determine whether the CNS event agent is connecting
to the gateway, connected, or active, and to display the gateway used by the event agent and its
IP address and port number.
Examples The following is sample output from the show cns config connections command:
Router# show cns config connections
The partial configuration agent is enabled.
Configuration server: 10.1.1.1
Port number: 80
Encryption: disabled
Config id: test1
Connection Status: Connection not active.
Related Commands
Release Modification
12.2(8)T This command was introduced.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
show cns config
outstanding
Displays information about incremental CNS configurations that have
started but not yet completed.
show cns config stats Displays statistics about the CNS configuration agent.