Cisco MWR 2941 - Show Ip Rtp Header-Compression

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show ip rtp header-compression
542
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
show ip rtp header-compression
To show Real-Time Transport Protocol (RTP) header compression statistics, use the show ip rtp
header-compression command in privileged EXEC mode.
show ip rtp header-compression [type number] [detail]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines The detail keyword is not available with the show ip rtp header-compression command on a Route
Switch Processor (RSP). However, the detail keyword is available with the show ip rtp
header-compression command on a Versatile Interface Processor (VIP). Enter the show ip rtp
header-compression type number detail command on a VIP to retrieve detailed information about RTP
header compression on a specific interface.
Examples The following example shows output from the show ip rtp header-compression command:
Router# show ip rtp header-compression
RTP/UDP/IP header compression statistics:
Interface Multilink1 (compression off, IETF, RTP)
Rcvd: 0 total, 0 compressed, 0 errors
0 dropped, 0 buffer copies, 0 buffer failures
Sent: 430 total 429 compressed
15122 bytes saved, 0 bytes sent
0 efficiency improvement factor
type number (Optional) Interface type and number.
detail (Optional) Displays details of each connection.
Note This keyword is not supported on the Cisco MWR 2941 router. See
“Usage Guidelines.”
Release Modification
11.3 This command was introduced.
12.1(5)T The command output was modified to include information related to the
Distributed Compressed Real-Time Transport Protocol (dCRTP) feature.
12.3(11)T The command output was modified to include information related to the
Enhanced Compressed Real-Time Transport Protocol (ECRTP) feature.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
12.4(19)MR2 This command was integrated into Cisco IOS Release 12.4(19)MR2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.