Cisco MWR 2941 - Network-Clock-Select Mode

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
network-clock-select mode
286
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
network-clock-select mode
The network-clock-select mode command specifies the router switching mode when recovering from a
failure. To remove a network-clock-select mode configuration, use the no form of this command.
network-clock-select mode {revert | nonrevert}
no network-clock-select mode {revert | nonrevert}
Syntax Description
Defaults The default setting is network-clock-select mode nonrevert.
Command Modes Global configuration
Command History
Examples The following example shows how to use the network-clock-select command:
Router# config t
Router(config)# network-clock-select mode revert
Router(config)# exit
Related Commands
nonrevert Sets the network clock to non-revertive mode.
revert Sets the network clock to revertive mode.
Release Modification
12.4(19)MR2 This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
set network-clocks
force-reselect
Forces the router to re-select the network clock.