EasyManua.ls Logo

Cisco MWR 2941 - Switch L2 Trust

Cisco MWR 2941
708 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
switch l2trust
650
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
switch l2trust
Enables layer 2 trust mode on the Cisco MWR 2941 gigabitEthernet ports. To disable layer 2 trust mode,
use the no form of this command.
switch l2trust
no switch l2trust
Command Default This command is disabled by default.
Command Modes Global configuration
Command History
Usage Guidelines This command enables layer 2 trusted mode for all gigabitEthernet ports on the 12.2(33)MRA.
Examples The following example shows the output generated by this command:
Router(config)# switch l2trust
Router(config)# exit
Related Commands
Release Modification
12.4(20)MR This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into 15.0(1)MR.
Command Description
show interface switchport
backup
Displays status information about the backup switchport.

Table of Contents

Related product manuals